诚信熔接网厂

1. Tools:

主机、切割刀、光纤、剥线钳、酒精（99%工业酒精最好，用75%的医用酒精也可）、棉花（用面巾纸也可）、热缩套管

Host, cutting knife, fiber, stripping pliers, alcohol (99% industrial alcohol best, with 75% medical alcohol can), cotton (with tissues can), heat shrinkable sleeve

2、放电实验：

2. Discharge experiment:

目的： 让光纤熔接机适应当前的环境

Objective: to adapt the fiber optic adapter to the current environment

为什么做： 更好的适应环境，放电更充分，熔接效果更好

Why to do it: better adapt to the environment, more fully discharge, better weld effect

怎么做： （1）、加入光纤，选择“放电实验”功能。屏幕显示出放电强度，直到出现“放电OK“为止。

How to do: (1), add fiber, choose the "discharge experiment" function. The screen displays the discharge strength until the "discharge OK" appears.

（2）、空放电，按ARC键

(2), air discharge, according to ARC key

做多少次： 过程会出现“放电过强，放电过弱“，直到放电OK止

How many times do you do it: the process will be "too strong, too weak" until the discharge OK stops.

什么时候做：（1）、位置改变时（一般超过300KM）

When to do it: (1), when the position is changed (generally more than 300KM)

（2）、海拔变化时（一般超过1000m）

(2), when the altitude is changed (generally more than 1000m)

（3）、在更换电极后一定需要做放电实验

(3) the discharge experiment must be done after replacing the electrode

（4）、纬度变化时

(4), latitudinal change

注意：不是每次熔接前都要做放电实验

Note: it is not a discharge experiment before every weld.

3、确认你所熔接的光纤类型和需要加热的热缩套管类型

3. Confirm the type of fiber you have fused and the type of heat shrinkable casing that needs to be heated

如何选择：光纤类型： 在熔接模式中选择SMF、MF、DSF、NZDF等

How to choose: fiber type: select SMF, MF, DSF, NZDF and so on in the splicing mode

4、制备光纤

4. Fabrication of optical fiber

光纤：纤芯、涂覆层、包层

Fiber: core, coating, cladding

我们要熔接的是裸纤，就是纤芯

We have to fuse the bare fiber, that is the core.

用光纤剥线钳剥除一段裸光纤出来，用酒精棉来清洁干净，然后用光纤切割刀来切割，切割长度按照上面参数来确定，切割刀上面有尺寸刻度，注意保持切割的端面保持垂直状态，误差一般是2°以内，1°以内，注意一下，先清洁后切割！

Using optical fiber stripping stripping pliers a bare fiber, cotton with alcohol to clean, and then use the optical fiber cutter to cut, cut length is determined according to the above parameters, the cutting knives with scales, keep the cutting face perpendicular to the state, the error is less than 2 degrees, 1 degrees, note first, clean cut!