| 熔接网技术要求 |
| 添加时间：2019/8/20 15:55:41 浏览次数： |
| 技术要求 technical requirement 钢筋焊接网的规格，应符合下列规定： The specifications of welded steel mesh shall conform to the following provisions: （1）钢筋直径宜为4~12mm； (1) The diameter of reinforcing bar should be 4-12 mm. （2）焊接网长度不宜超过12m，宽度不宜超过3.4m； (2) The length and width of the welding net should not exceed 12 m and 3.4 m respectively. （3）焊接网制作方向的钢筋间距宜为100、150、200mm，与制作方向垂直的钢筋间距宜为100~400mm，且应为10mm的整倍数。 (3) The spacing of steel bars in the fabrication direction of welding net should be 100, 150 and 200 mm, and the spacing of steel bars perpendicular to the fabrication direction should be 100-400 mm, and should be an integral multiple of 10 mm. （4）焊接网钢筋强度设计值：对冷轧带肋钢筋fy=360N/mm，对冷拔光圆钢筋fy=320N/mm。 (4) Strength design value of welded net steel bar: FY = 360N/mm for cold-rolled ribbed steel bar and FY = 320N/mm for cold-drawn round steel bar. |
| 上一页 裸纤的清洁 |
| 下一页 熔接网介绍 |
Copyright © 技术支持：遨游网络